Insulation plug IPL 60
Special plug for external insulation composite systems
With the insulation plug IPL 60 direct fastening into external insulation material is possible - without thermal bridge. It is therefore a perfect solution for fixing in thermal insulation composite systems, hard-foam boards, polystyrene boards and many other substrates. The IPL consists of ageing- and weather-resistant nylon, is temperature-resistant from -40 to +80 °C and, thanks to its sharp cutting tip, drills reliably through hard ETICS plaster (up to 7 mm) - without pre-drilling.
The IPL 60 with a head Ø 25 mm is ideal for light fixings such as small lamps, motion detectors and edge trim strips, which are fixed to the anchor with a chipboard screw Ø 4.5- 5.0 mm. Make the installation of the IPL 60 easier with the practical duo bit: no bit change is necessary during installation and the duo bit is available in three versions (TX20/TX40, TX25/TX40 and PZ2/TX40). This saves time and money.
Technical data:
- Type: IPL95
- Recess type: Nylon
- Recess type: TX40
- Plug length [mm]: Ld 58
- Screw diameter [mm]: ds 4,5-5,0
- Insertion depth [mm]: 30-50
- Units: 25pcs/Box
Advantages:
- Special plug for external insulation composite systems
- Direct fastening into the insulation material - no thermal bridge
- No predrilling necessary due to sharp cutting tip also drills reliably through hard ETICS plaster (? 7 mm)
- Nylon plug ageing and weather resistant
- Duo-Bit: One bit for plug and screw saves install-ation time and money because no bit change is necessary. PZ2/TX40, TX20/TX40 and TX25/TX40 available
- Ideal also for edge end profiles, the plug drills through bitumen sheets
Applications:
Further specifications
- Lamps
- Motion detector
- Letterbox
- Signs
- Clothes hook
Areas of application
- External Thermal Insulation Composite Systems (ETICS)
- Polystyrene boards
- Hard foam boards
- Wood fibre insulation boards (pre-drilling: 8mm for IPL60, 13mm for IPL95)
- Heraklith boards
Related Products
Are you not my partner yet? Do you have any questions?
Please call my export manager or write an email!